The MEQ Premium Magnetic Mount fits in minutes with no tools or drilling. Here's how to get the best result.
What's in the box
- MEQ Premium Magnetic Mount with magnetic feet
- Clamps and fixings to hold your Starlink Mini
Your Starlink Mini and power cable are sold separately unless you bought a kit.
Fitting your Starlink Mini to the mount
- Place your Starlink Mini face up into the mount.
- Fit the clamps and tighten the fixings evenly, a little at a time, until the dish is held firmly. Don't over-tighten.
- Connect your power cable to the Starlink Mini before you put the mount on the roof.
Placing the mount on your vehicle
- Check the roof is steel with the magnet test. If it isn't, fit Steel Discs first.
- Pick a spot with a clear view of the sky, away from roof racks, lights and anything taller that could block the signal.
- Clean the roof and the magnetic feet. Grit trapped under a magnet can scratch paint and reduce grip.
- Lower the mount straight down rather than sliding it into place.
- Route the cable through a door seal, rear window or cable entry so it isn't pinched.
- Open the Starlink app and follow the prompts to get online.
Removing the mount
Tilt the mount from one edge to break the magnets free, then lift it off. Don't drag it across the paint.
Before every trip: check the mount is firmly in place and the cable is secure. Remove the mount before going through a car wash.